Builders Edge 050010212000 Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro ne Builders Edge 050010212000. Builders Edge 050010212000 Installation Guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 2
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Shutter Clip
Installation Instructions
For Installation of Standard Louvers, Panels, Board and
Required for Installation:
Six Shutter-Clips per shutter
Nine #10 or equivalent (M5 metric) screws per shutter.
Length of screws is dependent on mounting surface.
Other fasteners may be required for specific surfaces.
Screw driver, electric drill, level, and pencil
Installation Notes:
Each shutter has ribs in the back of the top, center, and
bottom panels. Two clips are used in each of these
three areas. See the illustration at the right.
correct placement areas
for Shutter-Clips
Step 1:
Push a shutter clip partially onto the ribs at each corner of the
shutter with the mounting tab extending beyond the shutter (4
places). See Figure 1. DO NOT press the Shutter-Clips completely
on to the shutter at this time because they will be removed later.
Figure 1
Do not completely
fasten Shutter-Clips
to shutter at this time
Step 2:
Hold the shutter against the mounting surface in the position
where it will be attached. Mark the center hole of each shutter
clip (4 places). Draw lines vertically between the top and bottom
marks. After completing Step 2, remove the Shutter-Clips from
the shutter.
Figure 2
pencil marks
top of shutter
window
window trim
1-09-14
I-0027
MIPC8517
Part No. MIPC8451
Battens, and custom Board and Batten Shutters only.
Zobrazit stránku 0
1 2

Shrnutí obsahu

Strany 1 - Shutter Clip

Shutter ClipInstallation InstructionsFor Installation of Standard Louvers, Panels, Board andRequired for Installation:Six Shutter-Clips per shutterNin

Strany 2

Step 3:Step 4:After the Shutter-Clips are in position and fastened to the mounting surface, attach the shutter. Place the shutter over the Shutter-Cl

Komentáře k této Příručce

Žádné komentáře