Builders Edge 051010001002 Instalační příručka stáhnout pdf

Shutter Hardware

Installation Instructions

-For new or existing shutters,

Kit Contains:

(4) Hinges

(2) "S" Hooks

(10) Screws

"S" Hook Hinge

Step 1

Determine where the hinges will be installed. Typically the hinges are installed

near the ends of the shutters. See Figure at right.

Note: If placing hinges over Shutter Loks, be sure the pilot holes don't interfere

with the Shutter Loks.

Step 2

Using the marks on the front of the hinges as guides, use an 1/8" drill bit and

drill pilot holes through the hinge and shutter.

Step 3

Securely attach the hinges to the shutter with the enclosed screws.

Hinge Installation

"S" Hook Installation

Step 1

Place the "S" Hook in the desired location. Normally the hooks are installed

at the bottom corner of the shutter. See Figure 1 at right.

Step 2

On the back of the "S" Hook is a fin. This is where the screw will be placed.

After the position of the "S" Hook is determined, use an 1/8" drill bit to drill

through the fin and into the bottom of the shutter.

Step 3

Securely attach the "S" Hook to the shutter using the screws provided.

Louver, Panel, or Board and Batten

Shutter HardwareInstallation Instructions-For new or existing shutters,Kit Contains: (4) Hinges (2) "S" Hooks(10) Screws"S" Hoo

Žádné komentáře

Builders Edge 051010001002 Instalační příručka